How to apply the product
Surface Preparation
The surface must be solid, free of dust, moisture, and loose particles.
Primering
Apply a primer coat to the prepared surface using a roller or brush. After 6 hours, you can proceed with applying the decorative coating.
1st Layer Preparation
Pour 900 ml of water into the bucket from the package and add 2.5 kg of loose component. (360 ml of water per 1 kg of mixture). Mix the mixture thoroughly and let it stand for 5 min., then mix again.
1st Layer Application
Apply the mixed coating evenly over the prepared surface. The first layer serves to level the surface and as a base for decoration.
Drying
Let the first layer of coating dry for 24 hours.
2nd Layer Preparation
In a clean bucket, pour 900 ml of water and add 2.5 kg of the dry component (360 ml of water per 1 kg of mixture). Mix thoroughly and let it stand for 5 minutes, then mix again.
2nd Layer Application
Apply using decorative techniques such as “pulling” and “spreading.” The second layer creates an uneven concrete relief. After a short setting time (15-30 min.), the surface can be further finished by “smoothing.”
Drying
Allow the second layer to dry for 24 hours.
Highlight Layer Preparation
Prepare the highlighting coat by pouring component 3/B into component 3/A and mixing thoroughly for 3 minutes. If you are not using the full amount, mix at a weight ratio of 0.9 A : 1 B.
Highlight Layer Application
Apply the mixed solution with a velour roller onto the cured coating. Maintain a consumption rate of 0.1-0.15 kg/m². Thoroughly work the highlight into the surface relief. Apply a second layer after approximately 40 minutes. Always prepare a fresh mixture of the highlight according to the previous step.
How to apply the product
Surface Preparation
The surface must be solid, free of dust, moisture, and loose particles.
Primering
Apply the primer to the prepared surface using a roller or brush. After 6 hours, proceed with the application of the putty.
1st Layer Preparation
Pour 900 ml of water into the bucket from the package and add 2.5 kg of the dry component (360 ml of water per 1 kg of mixture). Mix thoroughly and let it stand for 5 minutes, then mix again.
1st Layer Application
Apply the mixed coating evenly over the prepared surface. The first layer serves to level the surface and as a base for decoration.
Drying
Let the first layer of coating dry for 24 hours.
2nd Layer Preparation
In a clean bucket, pour 900 ml of water and add 2.5 kg of the dry component (360 ml of water per 1 kg of mixture). Mix thoroughly and let it stand for 5 minutes, then mix again.
2nd layer Application
Apply using decorative techniques such as “pulling” and “spreading.” The second layer creates an uneven concrete relief. After a short setting time (15-30 min.), the surface can be further finished by “smoothing.”
Drying
Allow the second layer to dry for 24 hours.
1st Sealing Layer Application
Apply the sealing coat evenly over the entire surface using a roller. Apply at a rate of 0.2 kg/m², ensuring that the coating does not run down the wall but is absorbed into the substrate.